BIFINETT KH 1101 BOUILLOIRE DE 1-5 L - Kettle KOMPERNASS - Free user manual and instructions

USER MANUAL BIFINETT KH 1101 BOUILLOIRE DE 1-5 L KOMPERNASS

This kettle is intended for home use of heating water. It is not intended for use with other liquids or commercial or industrial use.

2. Technical Data

voltage 230 V / 50 Hz

power consumption 2,200 W

Important Information for Your Safety

Please observe the following instructions to avoid the hazard of electrical shock:

• Please ensure that the base and its electrical connections never get in contact with water. If the base should unintentionally get moist, let it dry out completely.
• Please ensure that the power cable never gets wet or moist in use. Never allow it to get pinched or otherwise damaged. Should the power cable or the plug get damaged, have the customer service replace it before you use the kettle again.
  Always pull the plug out of the socket after use. It is not sufficient to switch it off because the kettle is still on as long as the plug is in the socket.

Please observe the following instructions to avoid the hazard fire or injury:

• Always heat the water with the cover closed, because the automatic switch-off mechanism will not function otherwise and boiling water may spill over the edge.
• The kettle is very hot when in use and hot clouds of steam may escape. Therefore, always wear oven gloves.
• Make sure that the kettle is set up vertically in a stable position before you switch it on. Boiling water can make a kettle fall over if it is not set up in a stable position.
• Never leave a kettle unattended that is generating heat.
• Do not allow children or infirm persons to handle it without supervision because they may not always be able to correctly assess potential hazards.

3. Using the Kettle

Before you use the kettle, satisfy yourself that...

• the kettle, plug and power cable are in good working order...
• and all packaging material has been removed from the kettle.

Fill the kettle with water to the MAX mark and let it come to a boil once as described in the next number. Then pour off this water.

4. Boiling Water

Danger: Never place the electrical base near water - life-threatening danger!

Only boil as much water as you need. This saves electricity, water and time.

• Remove the pot to fill it.

1 Open the cover by pressing the release button.
Hold the pot vertically when filling it to ensure that the level indicator on the side properly indicates the water level. Fill the pot ...

• at least to the MIN mark to ensure that the kettle does not overheat,

• no more than to the MAX mark to ensure that boiling water does not spill over.

• Close the cover ...

• and place the pot on the base until it is set on its base completely straight.
• Now put the plug into the socket...
  3 and press the ON switch downward until it locks into place.

A lamp in the window of the level indicator indicates that the kettle is now heating up.
- The kettle switches itself off when the water is boiling properly. The ON switch pops out again and the lamp goes out.
In order to interrupt heating, push the ON switch up again (the lamp also goes out in this case).

Warning:

Please pull the plug out of the socket before you lift the pot from the base.

This prevents water from spilling onto the electrical connections in the base and causing a short-circuit.

For safety reasons and to avoid injuries do not open the lid when the water is boiling or very hot.

5. Cleaning and Care

Danger: Never open any of the device parts. No operating elements are located inside the device. An open housing can create the risk of a life-threatening electrical shock.
Never submerge any parts of the device in water or other liquids! This can create the risk of a life-threatening electrical shock if residual liquid comes into contact with powered components.

Before cleaning the kettle, ....

• pull the plug out of the socket and let the kettle cool off.
• Clean all exterior surfaces and the power cable with a slightly moist rinsing cloth. Dry the kettle off every time before using it again.
• Do not use any detergents, scouring agents or solvents. They may damage the components of the kettle.

If the kettle has calcium residues:

• Use a decalcifier from your household goods shop that is suited for food containers (such as a coffee machine decalcifier).
• Use a suitable decalcifier for the exterior stainless steel surfaces.

Removing/inserting the spout screen:

• Remove the cover and ...
  1 just pull the spout screen upwards.
  After cleaning, you can insert the screen again and press down firmly - and it's ready!

6. Storage

Let the kettle cool off completely before you put it away.

• Wind the power cable around the holder under the bottom of the kettle.
• Store the kettle in a dry place.

7. Disposal

Care for the environment. If you wish to dispose of the device, dispose of it at a collection site for recycling of electronics.

8. Warranty & Service

The warranty conditions and service address can be found in the enclosed warranty slip.

Bollitore da 1,5 I

Bifinett KH 1101

1. Uso